VCS VIP 10 Betriebsanweisung PDF herunterladen (Seite 18)

Installation Chapter 4

18 VIP 10

Connections

Camera/monitor

Depending on the device used, you can connect a video source (sender) or a

monitor (receiver). All cameras and video sources that generate a standard PAL

or NTSC signal and all monitors compatible with PAL or NTSC standards can be

used for this purpose.

– Connect the camera or another video source using a video cable (75 Ohms,

BNC plug) to the Video In BNC jack of the sender.

– Connect the video monitor using a video cable (75 Ohms, BNC plug) to the

Video Out BNC jack of the receiver.

Data interface

The bidirectional data interface is used to control equipment connected to the VIP

unit, such as a dome camera with a motorized lens.

The RS232/485 connection supports RS232, RS422 and RS485 communication

standards.

The serial interface is a Sub-D socket. For information on the pin assignment see

page 110.

The selection of controllable devices is growing constantly. The manufacturers of

this equipment can provide specific information on installation and control.

Warning!

Make use of the device documentation when installing and operating a

device that you want to control using the system. It contains important

safety instructions and information about authorized use.

Note

A video connection is necessary to transmit transparent data.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 121 122

Keine Kommentare

VCS VIP 10 Betriebsanweisung Seite 18