VCS VIP 10 Bedienungsanleitung PDF herunterladen (Seite 131)

VIP X1 | Installation and Operating Manual EN | 131

Bosch Security Systems | 2006-12 | V2.5 Appendix

– Enter 1 again. The terminal program displays the current IP address and

prompts you to enter a new IP address.

– Enter the desired IP address and press Enter. The terminal program displays

the new IP address.

– Use the displayed commands for any additional settings which you require.

Note

You must restart to activate the new IP address, a new subnet mask or a

gateway address.

Restart

Briefly interrupt the power supply to the VIP X1 for a restart (disconnect the

power supply unit from the mains supply and switch on again after a few sec-

onds).

Additional parameters

You can use the terminal program to check other basic parameters and modify

them where necessary. Use the on-screen commands in the various submenus

to do this.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 143 144

Keine Kommentare

VCS VIP 10 Bedienungsanleitung Seite 131