VCS VIP 1000 Betriebsanweisung PDF herunterladen (Seite 80)

Configuring the Receiver Chapter 7

80 VIP 1000

Alarm connections

You can select a number of options for the response of the VIP to an alarm. In

case of an alarm, the VIP can establish a connection to a predefined IP address,

e.g. a VIP sender, automatically. You can enter up to ten IP addresses which will

be selected in sequence by the unit until a connection is established.

Note

Sender and receiver must share the same subnet for connection set-up

(see page 86).

Connect on alarm:

Select On for the VIP to establish a connection automatically to a specified IP

address in the event of an alarm.

With the setting Follows input, the VIP holds the automatically set up connection

to a remote location as long as an alarm signal is present at its alarm input 1. You

can use this setting to establish a connection between two VIP units via a

connected on-off switch. In this case you don’t need a computer to set up the

connection.

Sending encoder:

Here you can select the encoder that is to be connected in case of alarm

dependent on the environment used (network configuration). In doing so,

consider the settings of the remote sender (MPEG-2/MPEG-4-ability).

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 125 126

Keine Kommentare

VCS VIP 1000 Betriebsanweisung Seite 80