VCS VIP 1000 Betriebsanweisung PDF herunterladen (Seite 89)

Chapter 7 Configuring the Receiver

VIP 1000 89

The new firmware will be decompressed and used to reprogram the flash

EPROM. The time necessary is indicated by the message going to reset

Reconnecting in ... seconds.

After the upload is completed successfully, the unit will restart automatically.

If the „operating status“ LED blinks red and yellow alternately, the upload has

failed and must be done again. This requires that you work from a special page:

– Enter the IP address of the unit in the browser and append /main.htm (for

example 192.168.0.12/main.htm).

– Repeat the upload.

Configuration download:

The VIP configuration data can be saved on a computer and the saved data

loaded on a unit from the computer.

– Click Download. A dialog will appear.

– Follow the instructions to save the current settings.

Configuration upload:

– Enter the full path of the file to upload or click Durchsuchen... to select the

desired file.

– Make sure that the file to be loaded originates from the same type of device as

the unit you want to reconfigure.

– Click Upload to begin transmitting the file to the unit. Transmission progress

can be monitored from the progress bar.

After the upload is completed, the new configuration will be activated. The time

necessary is indicated by the message going to reset Reconnecting in ...

seconds.

After the upload is completed successfully, the unit will restart automatically.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 125 126

Keine Kommentare

VCS VIP 1000 Betriebsanweisung Seite 89