VCS VIP 1000 Betriebsanweisung PDF herunterladen (Seite 86)

Configuring the Receiver Chapter 7

86 VIP 1000

– Enter the old IP address in the address field of the Web browser and append

/reset to it (e.g. 192.168.0.2/reset). The VIP will be restarted after

which it can only be accessed at the new IP address.

Unit IP address:

Enter the desired IP address for the VIP in this field. The IP address must be valid

for the network.

Subnet mask:

Enter the subnet mask corresponding to the inserted IP address here.

Gateway IP address:

Enter the IP address of the gateway here if the unit is to establish a connection

to a unit that is in another subnet. Otherwise, this field can remain empty (0.0.0.0).

Video/audio transmission:

If the device is used behind a firewall, TCP (HTTP port) should be selected as

the transmission protocol. For use in a local network, choose UDP.

Warning!

Multicast operation is possible only with the UDP protocol. The TCP

protocol does not support multicast connections.

Note

In UDP mode the MTU is 1514 bytes.

Ethernet link type:

If the VIP is connected to the network via a switch, both devices must be set for

the same type of network connection. If necessary, ask your network

administrator about the switch setting.

Choose Auto for an autosensing network connection. If necessary you can set

the value to 10 or 100 MBit/s and full or half-duplex mode (FD or HD).

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 125 126

Keine Kommentare

VCS VIP 1000 Betriebsanweisung Seite 86